3Com 4200G 12-Port Configuration Manual page 433

To do...
Set system information, and specify
to enable SNMPv1 or SNMPv2c on
the switch
Direct
configura
tion
Set a
community
name and
access
Indirect
permission
configura
tion
Set the maximum size of an SNMP
packet for SNMP agent to receive or
send
Set the device engine ID
Create/Update the view information
Follow these steps to configure basic SNMP functions (SNMPv3):
To do...
Enter system view
Enable SNMP agent
Use the command...
snmp-agent sys-info
{ contact sys-contact |
location sys-location |
version { { v1 | v2c | v3 }* |
all } }
snmp-agent community
Set a { read | write }
community-name [ acl
community
name acl-number | mib-view
view-name ]*
snmp-agent group { v1 |
Set an v2c } group-name [ read-view
SNMP read-view ] [ write-view
group write-view ] [ notify-view
notify-view ] [ acl acl-number ]
Add a user
snmp-agent usm-user { v1 |
to an
v2c } user-name group-name
SNMP
[ acl acl-number ]
group
snmp-agent packet
max-size byte-count
snmp-agent local-engineid
engineid
snmp-agent mib-view
{ included | excluded }
view-name oid-tree [ mask
mask-value ]
Use the command...
system-view
snmp-agent
1-3
Remarks
Required
By default, the contact
information for system
maintenance is " 3Com
Corporation.", the system
location is " Marlborough,
MA 01752 USA ", and the
SNMP version is SNMPv3.
Required
You can set
SNMPv1/SNMPv2c
community
through
configuration.
Indirect configuration is
compatible
SNMPv3. The added
user is equal to the
community name for
SNMPv1
SNMPv2c.
You can choose either
of them as needed.
Optional
1,500 bytes by default.
Optional
By default, the device
engine ID is "enterprise
number + device
information".
Optional
By default, the view name
is ViewDefault and OID is
1.
Remarks
—
Optional
Disabled by default.
You can enable SNMP agent by
executing this command or any
of the commands used to
configure SNMP agent.
an
name
direct
with
and