Configuring To Display The Time Stamp With The Utc Time Zone; Setting To Output System Information To The Console - 3Com 4200G 12-Port Configuration Manual

If the system information is output before you input any information following the current command
line prompt, the system does not echo any command line prompt after the system information
output.
In the interaction mode, you are prompted for some information input. If the input is interrupted by
system output, no system prompt (except the Y/N string) will be echoed after the output, but your
input will be displayed in a new line.

Configuring to Display the Time Stamp with the UTC Time Zone

To add UTC time zone to the time stamp in the information center output information, you must:
Set the local time zone
Set the time stamp format in the output direction of the information center to date
Configure to add the UTC time zone to the output information
Follow these steps to configure to display time stamp with the UTC time zone:
To do...
Set the time zone for the system
Enter system view
Set the time
stamp format
in the output
direction of
the
information
center to
date
Set to display the UTC time zone
in the output information of the
information center

Setting to Output System Information to the Console

Setting to output system information to the console
Follow these steps to set to output system information to the console:
To do...
Enter system view
Enable the information center
clock timezone zone-name
{ add | minus } time
system-view
Log host
info-center timestamp
direction loghost date
Non log host info-center timestamp { log |
direction trap | debugging } date
info-center timestamp utc
Use the command...
system-view
info-center enable
Use the command...
1-8
Remarks
Required
By default, UTC time zone is
set for the system.
—
Required
Use either command
Required
By default, no UTC time zone
is displayed in the output
information
Remarks
—
Optional
Enabled by default.