3Com 4200G 12-Port Configuration Manual page 657

Configuration procedure
Configure remote-ping Server (Switch B):
# Enable the remote-ping server and configure the IP address and port to listen on.
<Sysname> system-view
[Sysname] remote-ping-server enable
[Sysname] remote-ping-server tcpconnect 10.2.2.2 8000
Configure remote-ping Client (Switch A):
# Enable the remote-ping client.
<Sysname> system-view
[Sysname] remote-ping-agent enable
# Create a remote-ping test group, setting the administrator name to administrator and test tag to
tcpprivate.
[Sysname] remote-ping administrator tcpprivate
# Configure the test type as tcpprivate.
[Sysname-remote-ping-administrator-tcpprivate] test-type tcpprivate
# Configure the IP address of the remote-ping server as 10.2.2.2.
[Sysname-remote-ping-administrator-tcpprivate] destination-ip 10.2.2.2
# Configure the destination port on the remote-ping server.
[Sysname-remote-ping-administrator-tcpprivate] destination-port 8000
# Configure to make 10 probes per test.
[Sysname-remote-ping-administrator-tcpprivate] count 10
# Set the probe timeout time to 5 seconds.
[Sysname-remote-ping-administrator-tcpprivate] timeout 5
# Start the test.
[Sysname-remote-ping-administrator-tcpprivate] test-enable
# Display test results.
[Sysname-remote-ping-administrator-tcpprivate] display remote-ping results administrator
tcpprivate
remote-ping entry(admin administrator, tag tcpprivate) test result:
Destination ip address:10.2.2.2
Send operation times: 10
Min/Max/Average Round Trip Time: 4/7/5
Square-Sum of Round Trip Time: 282
Last complete test time: 2000-4-2 8:26:2.9
Extend result:
SD Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0
System busy operation number: 0
Operation sequence errors: 0
Other operation errors: 0
Receive response times: 10
DS Maximal delay: 0
Operation timeout number: 0
Connection fail number: 0
Drop operation number: 0
1-27