3Com 4200G 12-Port Configuration Manual page 643

To do...
Configure the
destination port
Configure the source
IP address
Configure the source
port
Configure the test
type
Configure the number
of probes per test
Configure the
maximum number of
history records that
can be saved
Configure the data
packet size
Configure the
automatic test interval
Configure the probe
timeout time
Configure the service
type
Start the test
Display test results
9) Configuring DNS test on remote-ping client
Follow these steps to configure DNS test on remote-ping client:
To do...
Enter system view
Use the command...
destination-port
port-number
source-ip ip-address
source-port port-number
test-type { udpprivate |
udppublic }
count times
history-records number
datasize size
frequency interval
timeout time
tos value
test-enable
display remote-ping
results [ admin-name
operation-tag ]
Use the command...
system-view
1-13
Remarks
Required in a Udpprivate test
A Udppublic test is a UDP connection
test on port
remote-ping-server udpecho ip-address
7 command on the server to configure
the listening service port; otherwise the
test will fail. No port number needs to be
configured on the client; any destination
port number configured on the client will
not take effect.
By default, no destination port number is
configured.
Optional
By default, no source IP address is
configured.
Optional
By default, no source port is specified.
Required
By default, the test type is ICMP.
Optional
By default, one probe is made per test.
Optional
By default, the maximum number is 50.
Optional
By default, the data packet size is 100
bytes.
Optional
By default, the automatic test interval is
zero seconds, indicating no automatic test
will be made.
Optional
By default, a probe times out in three
seconds.
Optional
By default, the service type is zero.
Required
Required
The display command can be executed in
any view.
Remarks
—
7. Use the