3Com 4200G 12-Port Configuration Manual page 235

a real-time accounting packet to the RADIUS servers once in every 15 minutes. A user name is
sent to the RADIUS servers with the domain name truncated.
The user name and password for local 802.1x authentication are "localuser" and "localpass" (in
plain text) respectively. The idle disconnecting function is enabled.
Network diagram
Figure 1-12 Network diagram for AAA configuration with 802.1x and RADIUS enabled
Configuration procedure
Following configuration covers the major AAA/RADIUS configuration commands. Refer to AAA
Operation for the information about these commands. Configuration on the client and the RADIUS
servers is omitted.
# Enable 802.1x globally.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] dot1x
# Enable 802.1x on GigabitEthernet 1/0/1.
[Sysname] dot1x interface GigabitEthernet 1/0/1
# Set the access control method to MAC-based (This operation can be omitted, as MAC-based is the
default).
[Sysname] dot1x port-method macbased interface GigabitEthernet 1/0/1
# Create a RADIUS scheme named "radius1" and enter RADIUS scheme view.
[Sysname] radius scheme radius1
# Assign IP addresses to the primary authentication and accounting RADIUS servers.
[Sysname-radius-radius1] primary authentication 10.11.1.1
[Sysname-radius-radius1] primary accounting 10.11.1.2
# Assign IP addresses to the secondary authentication and accounting RADIUS server.
1-21