3Com 4200G 12-Port Configuration Manual page 14

Configuration
The change to console port configuration takes effect immediately, so the connection may be
disconnected when you log in through a console port and then configure this console port. To configure
a console port, you are recommended to log in to the switch in other ways. To log in to a switch through
its console port after you modify the console port settings, you need to modify the corresponding
settings of the terminal emulation utility running on your PC accordingly in the dialog box shown in
Figure 2-4.
Follow these steps to set common configuration of console port login:
To do...
Enter system view
Enter AUX user interface view
Set the baud
rate
Set the check
Configure mode
the console
port
Set the stop bits
Set the databits
Configure the command level
available to users logging in to
the user interface
Enable terminal services
Set the maximum
Optional
number of lines the
By default, the screen can contain up to 24 lines.
screen can contain
Optional
Set history
command buffer
By default, the history command buffer can contain up
size
to 10 commands.
Optional
Set the timeout time
of a user interface
The default timeout time is 10 minutes.
Use the command...
system-view
user-interface aux 0
speed speed-value
parity { even | none |
odd }
stopbits { 1 | 1.5 | 2 }
databits { 7 | 8 }
user privilege level level
shell
Remarks
—
—
Optional
The default baud rate of a console
port is 9,600 bps.
Optional
By default, the check mode of a
console port is none, that is, no
check is performed.
Optional
The stop bits of a console port is 1.
Optional
The default databits of a console port
is 8.
Optional
By default, commands of level 3 are
available to users logging in to the
AUX user interface, and commands
of level 0 are available to users
logging in to the VTY user interface.
Optional
By default, terminal services are
available in all user interfaces.
2-4
Remarks