3Com 4200G 12-Port Configuration Manual page 565

To do...
Query a specified file on the
FTP server
Download a remote file from
the FTP server
Upload a local file to the remote
FTP server
Rename a file on the remote
server
Log in with the specified user
name and password
Connect to a remote FTP
server
Terminate the current FTP
connection without exiting FTP
client view
Terminate the current FTP
connection and return to user
view
Display the online help about a
specified command concerning
FTP
Enable the verbose function
Specifying the source interface and source IP address for an FTP client
You can specify the source interface and source IP address for a switch acting as an FTP client, so that
it can connect to a remote FTP server.
Follow these steps to specify the source interface and source IP address for an FTP client:
To do...
Specify the source interface
used for the current connection
Specify the source IP address
used for the current connection
Enter system view
Use the command...
dir [ remotefile ] [ localfile ]
ls [ remotefile ] [ localfile ]
get remotefile [ localfile ]
put localfile [ remotefile ]
rename remote-source
remote-dest
user username [ password ]
open { ip-address |
server-name } [ port ]
disconnect
close
quit
bye
remotehelp
[ protocol-command ]
verbose
Use the command...
ftp { cluster | remote-server }
source-interface
interface-type interface-number
ftp { cluster | remote-server }
source-ip ip-address
system-view
1-7
Remarks
Optional
If no file name is specified, all
the files in the current directory
are displayed.
The difference between these
two commands is that the dir
command can display the file
name, directory as well as file
attributes; while the Is
command can display only the
file name and directory.
Optional
Optional
Enabled by default.
Remarks
Optional
Optional
—