Configuring The Attributes Of Data To Be Sent To Radius Servers - 3Com 4200G 12-Port Configuration Manual

To do...
Set the status of the secondary
RADIUS
authentication/authorization
server
Set the status of the secondary
RADIUS accounting server

Configuring the Attributes of Data to be Sent to RADIUS Servers

Follow these steps to configure the attributes of data to be sent to RADIUS servers:
To do...
Enter system view
Create a RADIUS scheme and
enter its view
Set the format of the
usernames to be sent to
RADIUS server
Set the units of data flows to
RADIUS servers
Set the MAC address format of
the Calling-Station-Id (Type 31)
field in RADIUS packets
Set the source IP address of
outgoing RADIUS messages
Use the command...
state secondary
authentication { block |
active }
state secondary accounting
{ block | active }
Use the command...
system-view
radius scheme
radius-scheme-name
user-name-format
{ with-domain |
without-domain }
data-flow-format data { byte |
giga-byte | kilo-byte |
mega-byte } packet
{ giga-packet | kilo-packet |
mega- packet | one-packet }
calling-station-id mode
{ mode1 | mode2 }
{ lowercase | uppercase }
RADIUS scheme view
nas-ip ip-address
System view
radius nas-ip ip-address
2-16
Remarks
Remarks
—
Required
By default, a RADIUS scheme
named "system" has already
been created in the system.
Optional
By default, the usernames sent
from the switch to RADIUS
server carry ISP domain
names.
Optional
By default, in a RADIUS
scheme, the data unit and
packet unit for outgoing
RADIUS flows are byte and
one-packet respectively.
Optional
By default, the MAC address
format is XXXX-XXXX-XXXX,
in lowercase.
Optional
By default, no source IP
address is set; and the IP
address of the corresponding
outbound interface is used as
the source IP address.