Ipv6 Telnet - 3Com 4200G 12-Port Configuration Manual

To do...
Download/Upload files from
TFTP server
When you use the tftp ipv6 command to connect to the TFTP server, you must specify the "–i" keyword
if the destination address is a link-local address.

IPv6 Telnet

Telnet protocol belongs to application layer protocols of the TCP/IP protocol suite, and is used to
provide remote login and virtual terminals. The device can be used either as a Telnet client or a Telnet
server.
As the following figure shows, the Host is running Telnet client application of IPv6 to set up an IPv6
Telnet connection with Device A, which serves as the Telnet server. If Device A again connects to
Device B through Telnet, the Device A is the Telnet client and Device B is the Telnet server.
Figure 2-2 Provide Telnet services
Configuration prerequisites
Enable Telnet on the Telnet server and configure the authentication method. For details, refer to Login
Operation in this manual.
Follow these steps to set up IPv6 Telnet connections:
To do...
Perform the telnet command
on the Telnet client to log in to
other devices
When you use the telnet ipv6 command to connect to the Telnet server, you must specify the "–i"
keyword if the destination address is a link-local address.
Use the command...
tftp ipv6 remote-system [ -i
interface-type
interface-number ] { get | put }
source-filename
[ destination-filename ]
Use the command...
telnet ipv6 remote-system [ -i
interface-type interface-number ]
[ port-number ]
2-3
Remarks
Required
Available in user view
Remarks
Required
Available in user view