Proxy And Registration Section - Cisco WRP500 Administration Manual

Line page
R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
Refer Target Bye Delay
Referee Bye Delay
Refer-To Target
Contact
Sticky 183
Auth INVITE
Voice tab > Line page >
Call Feature Settings section
Blind Attn-Xfer Enable
Xfer When Hangup
Conf
Voice tab > Line page >

Proxy and Registration section

Proxy
Outbound Proxy
Cisco WRP500 Administration Guide
A-34
For the Refer Target Bye Delay, enter the appropriate period of time
in seconds.
The default is 0.
For the Referee Bye Delay, enter the appropriate period of time in
seconds.
The default is 0.
To contact the refer-to target, select yes. Otherwise, select no.
The default is no.
If this feature is enabled, the IP telephony ignores further 180 SIP
responses after receiving the first 183 SIP response for an outbound
INVITE. To enable this feature, select yes. Otherwise, select no.
The default is no.
When enabled, authorization is required for initial incoming
INVITE requests from the SIP proxy.
Enables the WRP500 to perform an attended transfer operation by
ending the current call leg and performing a blind transfer of the other
call leg. If this feature is disabled, the WRP500 performs an attended
transfer operation by referring the other call leg to the current call leg
while maintaining both call legs. To use this feature, select yes.
Otherwise, select no.
The default is no.
Makes the ATA perform a transfer when a conference call has
ended. Select yes or no from the drop-down menu.
The default is yes.
SIP proxy server for all outbound requests.
SIP Outbound Proxy Server where all outbound requests are sent as
the first hop.
Appendix A Advanced Voice Fields