Ricoh MP C3004 Field Service Manual page 703

19. Turn the power ON.
The screen "Program/Change Administrator" will be displayed in the language that is the same
language as the time when the data was uploaded to the SD card in step 5.
20. Execute SP5-755-002 (Hide Administrator Password Change Scrn).
After you execute this SP and exit SP mode, the Home screen is displayed and user functions can
be used.
21. Check that the fax and scanner icons are displayed, and then change the following SP
settings.
a. SP5-193-001 (External Controller Info. Settings) Change the value from 0 to 1.
b. SP5-895-001 (Application invalidation: Printer) Change the value from 0 to 1.
c. SP5-895-002 (Application invalidation: Scanner) Change the value from 0 to 1.
22. If the security functions (e.g. Stored file encryption/ Auto Erase Memory Setting) were
applied, set the functions again.
23. Ask the customer to restore their address book. Or restore the address book data using
SP5-846-052 (UCS Setting: Restore All Addr Book), and ask the customer to ensure the
address book data has been restored properly.
• If you obtained the backup of the customer's address book data in step 3, delete the backup
immediately after the NV-RAM replacement to avoid accidentally taking out the customer's
data.
24. Output all the SMC data with SP5-990-001 and make sure all the SP/UP settings except
for counter information are properly restored, by checking the SMC data obtained in step
2.
• The counters will be reset.
25. When equipped with fax, make sure that the list printed in steps 7-1 to 7-2 are the same
as the sender information that you wrote down in step 7-3.
If the setting is different from the original setting after the replacement of the NVRAM,
then set it again to the original setting.
26. Execute the process control (SP3-011-001).
27. Execute the ACC (Copy).
28. Execute the ACC (Printer).
29. Cycle the power OFF/ON.
• If you cannot execute SP5-824-001 or SP5-825-001 for some reason, try all the following things.
Electrical Components
695