Stapleless Stapler Initial Settings; How To Change The Setting Of Staple Method For Stapleless Stapler - Ricoh MP C3004 Field Service Manual

2. Installation
41. Ensure that the operation panel displays finisher jobs properly and that it works properly.

Stapleless Stapler Initial Settings

• To adjust the strength of the crimp between sheets of stapled paper, there is a setting to select either
single or double stapling.
• The crimp is weakened when there is an image (toner) at the point which is to be stapled. There
also is a setting to mask the image on the point for stapling, in order to prevent the crimp from
being weakened.
• Depending on users demands, explain the settings/methods of the settings by checking the
following instructions.

How to change the setting of Staple Method for Stapleless Stapler

Use this procedure to select the type of stapling that is done by the stapleless stapler.
Note that if you change the finisher type from Finisher SR3210 to Internal Finisher SR3180, which has
the same type of stapleless staple unit, the current setting in [Stapling Method for Stapleless Stapler] is
not carried over, so configure the setting again.
1. Press the [User Tools] icon on Home screen.
2. Press [Machine Features] > [System Setting] > [General Setting] >[Stapling Method for
Stapleless Stapler].
3. Select [Double] or [Single].
336