Duplex Exit Sensor: Lag Jam: Cause Code 065 - Ricoh MP C3004 Field Service Manual

6. Troubleshooting
• Reconnect the connector.
• Replace the sensor.
• Replace the Paper Transport IOB.
• Replace the harness.
Target Part/SP No.: Duplex/ Bypass Motor / SP5-804-071 (Duplex Bypass
Motor:CW:Standard Speed)
Turn the referenced motor OFF with OUTPUT check
Turn the referenced motor ON with OUTPUT check
Solution:
• Reconnect the connector.
• Replace the motor.
• Replace the Paper Transport IOB.
• Replace the harness.
Checking paper jam, or paper status
Check if there is no double feeding.
Check if the paper is curled too much.
Check if extra thin paper or thick paper exceeding the
supported paper thickness is being used.
Check if the paper thickness and size are detected correctly.

Duplex Exit Sensor: Lag Jam: Cause Code 065

Target Part/SP No.:Duplex Exit Sensor / SP5-803-010
Execute an INPUT check when there is no paper at the
position of the referenced sensor.
Execute an INPUT check when there is paper at the position
of the referenced sensor.
1124
Cause verification
Cause verification
Problem Judgement
Drive sound heard
Drive sound not heard
Fan the paper.
If the paper is curled too much, switch
on the anti-condensation heater for
paper tray.
Use a supported paper type.
Set the paper thickness and size to the
correct value.
Problem Judgement
0 :Paper detected
1: Paper not detected