Table of Contents
Advertisement
3 To specify multiple recipients, repeat steps 1 and 2.
NOTE:
• If you have entered an incorrect value, tap the number, select Remove from the popup menu,
and delete the incorrect value.
To modify the incorrect value, select Edit from the popup menu.
Entering Specific Symbols
When specifying a recipient, you can use the following features to enter specific symbols
on the touch screen.
Feature
Button
Enter pause
, (Dial
Pause)
Detect the
= (Wait)
tone
Mask the
/ (Mask)
entered value
: (Pulse →
Switch to the
Tone)
PB signal
Transmit using
S (Password) When a password has been set,
a password
Starting the Fax Job
1 Select Send.
NOTE:
• If the document has been loaded in the document feeder, do not hold down the document
while it is being conveyed.
• If you have more documents to fax, select Add Page on the touch screen while the current
document is being scanned. This allows you to send the documents as one set of data.
If you finished scanning, skip steps 2 to 4.
254
|
Faxing
Function
Used to enter a pause.
One pause is 3 seconds.
You can enter pauses of 6 seconds,
9 seconds, etc. with additional
button presses.
Used to perform the tone detection
within the specified time length.
Used to mask the entered value by
displaying as "*".
Used to switch the tone signal from
DP to PB.
transmission will start only if the
password matches the ID number
on the remote terminal.
Input method
1. Select
to switch the
onscreen keypad.
2. Select , (Dial Pause).
(Example)
0,123 ...
0,,123 ...
1. Select
to switch the
onscreen keypad.
2. Select = (Wait).
1. Select
to switch the
onscreen keypad.
2. Select / (Mask) to start masking.
3. Enter the value to be replaced
with "*" for showing on the screen.
4. Select / (Mask) to finish
masking.
(Input Example)
a/1234/5678/90ab
(Display Example)
a/****/5678/****
1. Select
to switch the
onscreen keypad.
2. Select : (Pulse → Tone).
1. Select
to switch the
onscreen keypad.
2. Select S (Password).
(Example)
0312345678S12345678
Advertisement
Table of Contents
