Table of Contents
Advertisement
Status Code
025-596
An error occurred. Contact Dell.
025-597
"026-001" - "026-999"
Status Code
026-400
Connect up to two devices to the USB host port. Turn off the printer, and turn it on again.
026-402
Wait until the job finishes.
026-700
By Address Book operation, the machine received an unsupported protocol from the LDAP
server.
Contact customer support if this failure is repeated.
026-701
Try the same operation. If the only one query is being submitted to the Address Book, the
machine's software may be defective. Contact customer support if this failure is repeated.
026-702
The number of accesses from the LDAP server to the machine by Address Book operation
exceeded the machine's processing capability.
Try the same operation. Contact customer support if this failure is repeated.
026-703
Authentication was canceled when you added a document.
Authenticate when documents are added.
026-710
• Ask the sender to send the e-mail encrypted by 3DES.
• Disable the FIPS140 validation mode of the machine.
026-711
• Reduce the resolution (scan quality) of the scan parameters and execute the operation
again.
• Reduce the number of document pages and then execute the operation again.
026-712
An error occurred while operating from Dell Printer Configuration Web Tool.
Wait for a while and try the same operation again.
026-718
The combination of the specified features such as Document Size, Paper Size, Paper Tray,
2 sided printing, and Output Tray is incompatible.
026-719
Wait for a while and try the same operation again. Contact customer support if this failure
is repeated.
026-720
The available space of the USB memory device is not sufficient.
Confirm the amount of available space.
026-721
USB memory device error.
Check the following conditions:
• The USB memory device is inserted into the USB memory slot.
• The USB memory device is accessible from your computer.
• The unencrypted USB memory device is used.
026-722
Initialize the USB memory device on a computer with the following file format, and then
execute the operation again.
• Supported file formats: FAT12, FAT16 (FAT), FAT32
NOTE:
• NTFS is not supported.
• A software-encrypted USB memory device is not supported.
Contact customer support if this failure is repeated.
• Check that the medium is not inserted or removed, or the other medium is not inserted,
026-723
while the machine is referencing the medium.
• Check that the file in the medium can be accessed via a computer.
026-726
Modify the machine configuration information in the print driver screen to match the
actual machine configuration.
026-727
• Remove unusable characters from the path name of the file location.
• Set the path in the range of 1 to 255 bytes.
Cause and Remedy
Cause and Remedy
Understanding Printer Messages
319
|
Advertisement
Table of Contents
