Chapter 1: Installation; Site Overview & Planning - HySecurity SlideSmart DC 15 Installation And Reference Manual

S O
ITE VERVIEW
Be sure to place the
WARNING
WARNING signs on both
sides of the gate. For your records, take a
photograph of the completed installa on site.
Attach WARNING Signs
Public Side
¼
Maximum 2 " (57mm) width
between vertical bars
Edge sensor
on trailing
edge
Photo eye (entrapment protection shown in four locations)
Physical stop - weld stops at both ends of V track
SlideSmart DC 15
Duty cycle: continuous
Power, single phase: Switch selectable
115 volts, 3 amps, 50/60 Hertz
230 volts, 1.5 amps, 50/60 Hertz
½
Motor: hp
Gate speed: 1ft/s
Gate weight: Maximum 1500lbs (675kg)
Note:For SlideSmart DC Solar operators, refer to www.hysecurity.com
Revision D
& P
LANNING
Earth ground
Target magnet on chain
Figure 1-1.
Installation
Installation
Keypad or Card Reader
Mount access control
devices at least 6ft
beyond gate.
Edge sensor on
leading edge
To comply with ASTM F2200, a screened wire mesh
extends to the top of the gate or to a minimum
height of 6 ft. (183cm) if a 2¼" (57mm) or larger
gap exists between the vertical bars.
SlideSmart DC 10F
Duty cycle: continuous
Power, single phase: Switch selectable
115 volts, 3 amps, 50/60 Hertz
230 volts, 1.5 amps, 50/60 Hertz
½
Motor: hp
Gate speed: 2ft/s
Gate weight: Maximum 1000lbs (450kg)
Site Overview & Planning
Chapter 1
Pedestrian gate
Make sure a separate walk-
through entrance is avail-
able and its pedestrian
path is clearly
designated.
Photo eye
Physical
V track stop
Secure Side
1-1