Using The Smart Dc Controller Buttons In Run Mode - HySecurity SlideSmart DC 15 Installation And Reference Manual

Using the Smart DC Controller Buttons in RUN Mode

The Run Mode buttons are distinguished by the fact that their name appears above each button. The
Controller buttons with text above and below function differently depending on the mode of the operator.
Three different modes exist:
• Run Mode - gate is operational awaiting commands.
• Menu Mode - motor disengages and operator commands are ignored. Menu navigation and menu
selection can be accomplished using the Smart DC Controller buttons or through a START software
connection via the USB port. Refer to
• Fault Mode - errors, faults or alerts appear on the display. Some errors or faults can be reset with the STOP
button while more serious faults require the RESET button or cycling power. Faults indicate a need for
diagnosis and resolution. Refer to
Pressing OPEN
opens the gate.
Pressing CLOSE
closes the gate.
Figure 3-5. Function of Smart DC Controller Buttons in Run Mode
Revision D
Using the Smart DC Controller Buttons In Menu
Smart DC Controller
HYSECURITY
GATE CLOSED
OPEN CLOSE
PREV NEXT SELECT
Pressing STOP
stops gate travel.
Display and Menu Options
Troubleshooting.
STOP MENU RESET
Run Mode
Mode.
Pressing RESET
clears error codes and
returns to Run Mode.
Pressing MENU
scrolls through operator status displays
and accesses the User Menu. The
CLOSE TIMER display appears which
presents the first of twelve
programmable displays.
Note: Pressing the MENU button
twice, bypasses the operator status
displays.
3-5