General Maintenance; Smart Touch Analyze And Retrieve Tool; What You Need; Installing Start Software - HySecurity SlideSmart DC 15 Installation And Reference Manual

G
ENERAL

Smart Touch Analyze and Retrieve Tool

HySecurity provides Smart Touch Analyze and Retrieve Tool (START) software to help HySecurity gate
operator users and installers conduct the following field service activities:
• Configure installer and user menu settings
• View the operator history (event) log
• Display monitored inputs for operator diagnostics
• Load Smart DC Controller (SDC) operator code
With START software loaded on your laptop computer, you have an
invaluable management tool for all HySecurity operators. Either the USB
port or the RS-232 serial port, found on the Smart DC Controller (see
Figure 6-16), allows you to download system diagnostics and upload
system configurations using the START software. The free START
software is conveniently located on the
Instructions for downloading START are found on the website, as well.
W Y N
HAT OU EED
• Standard USB 2.0 A-B communications cable. If you are using the
HySecurity RS-232 to USB adapter, be sure to install the USB driver
in your laptop.
• Laptop computer with Windows PC operating system (XP, Vista, or
Windows 7)
• Minimum 128MB of RAM
• Minimum 5MB of hard drive disk space
• VGA graphics card (minimum resolution of 800 x 600)
I START S
NSTALLING
Read the START User Manual, and then take the following steps to download START software:
1. Bring up your web browser and type in
2. Click Technical Support (left column) on the HySecurity home page.
3. Enter your user name and password. If you do not have a user name, register as an online member.
4. Click to Download: S.T.A.R.T. software for Smart Touch and Smart DC.
5. Read the End User License Agreement and, if you agree to the terms, click on, I accept (bottom of the
page).
6. Click RUN. A setup window appears.
Revision D
M
AINTENANCE
www.hysecurity.com
OFTWARE
http://www.hysecurity.com
website.
Reference

General Maintenance

RS-232
Connect to RS-232 with
a HySecurity adapter.
If using a USB cable,
connect it to the USB port.
USB PORT
Figure 6-16.
in the command line.
RS-485
COMMUNICATION
6-27