Pad Condition - HySecurity SlideSmart DC 15 Installation And Reference Manual

Site Overview & Planning

Pad Condition

1. Follow the local building codes to
identify the frost line and determine
the required depth of the concrete pad.
HySecurity recommends a minimum
16-inch depth with a minimum 2-inch
extension above ground level. Refer to
Figure 1-2 and Figure 1-3.
2. Before pouring the pad, consider
conduit placement so it fits within the
confines of the 6.9 x 12-inch cutout in
the SlideSmart base as shown in
Figure 1-2. Run separate conduits for:
• high voltage wiring (115-230V
supply power) including
equipment ground
• low voltage wiring (12V and 24V
accessory power)
• vehicle loop control wiring
• master/slave connections
• earth ground (NEC/NFPA)
3. Extend conduit height 2-inches (5cm) above the pad (4-inches (9cm) above ground level). Make sure the
concrete forms are square with the gate and the pad is level. The operator footprint, with covers, is
approximately an 18-inch square (4.7cm). See Figure 1-2 for the minimum pad dimensions.
SlideSmart DC
operator
Chain
Ground
wire & rod
Consult local
codes for
proper depth
1-2
(16.3cm)
.
10
(26.7cm)
Concrete
pad
Ground
lug
3 max.
(91.4cm)
Concrete pad
(depth set per
Cut-away
local codes) view
High voltage wires
Main AC power
Grounding rod depth at
10 (3m) or per local code
SlideSmart Installation and Reference Manual
6.4"
Area
cut out
5"
conduit
6.9 x 12"
(17.5 x 30.5cm)
1.6"
(4.1cm)
10.38"
(26.4cm)
19" minimum
(48.3cm)
Figure 1-2.
Conduit runs
2" (5cm) above
concrete pad
Minimum pad
height is 2" (5cm)
above grade level.
Grade level
Vehicle loop
control wires
Extra conduit
(Master/Slave power)
(Conduit may be shared with low voltage wires)
Low
voltage/Communica on wires
Chain
#40 Roller
for
Slotted holes (4x) for
concrete anchors:
½ - 13 x 3½"
20.7"
(52.6cm)
Figure 1-3.
Revision D
Gate
21"
(53.3cm)