Adjusting The Close Timer - HySecurity SlideSmart DC 15 Installation And Reference Manual

User Menu

Adjusting the Close Timer

The close timer assigns how many seconds will pass before the operator initiates closure of a fully opened gate
after all open commands and reversing sensor inputs have ceased. Every gate operator needs to have the close
timer set to a specific number of seconds unless a hard-wired closing device is connected to the unit such as a
push button station.
To adjust the time (1 to 99 seconds) it takes before the operator initiates gate closure, take the following steps:
1. At a gate status display, press the MENU button
twice. This accesses the User Menu and the CLOSE
TIMER display appears.
2. Use the SELECT, and then NEXT or PREV buttons
to navigate and change the number on the display.
Note:Keep the close time at zero if gate personnel operate
the gate or the owner plans to use a remote control.
3. To exit the User Menu, press the MENU button.
The gate status appears in the display indicating you
have returned to Run Mode.
3-8 SlideSmart DC Installation and Reference Manual
CT 0 (OFF)
CLOSE TIMER
OPEN CLOSE STOP
SELECT
PREV NEXT
MENU RESET
Revision D