Concrete Pad Mount - HySecurity SlideSmart DC 15 Installation And Reference Manual

C
ONCRETE
Chain to Gate
Ideal distance =
Minimum distance = 2½" (5cm)
6.4"
(16.3cm)
.
10 5"
(26.7cm)
1.6"
(4.1cm)
Concrete
pad
Install the operator, by taking the following steps:
1. Place the operator on the pad to best suit the conduit as
shown in Figure 1-2. Use the operator as a template and
center it on the pad. The chain path must be parallel
with the gate.
2. Assess any limitations in the chain path such as gate
support posts. Adjust the operator's location as required.
Mark the mounting locations based on gate, operator,
and chain requirements. Mark the drill point at the
center of the slot to allow for adjustments.
See Figure 1-4 and Figure 1-9.
3. Remove the operator from the concrete pad and drill the
holes for the concrete anchors. See Tip.
4. Mount the operator with four ½ - 13 x 3½-inch
concrete anchors as shown in Figure 1-10.
5. For additional types of mounting options, refer to the
Appendix.
Revision D
P M
AD OUNT
3¾" (9.5cm)
Conduit
cut out
10.38"
(26.4cm)
19" minimum
(48.3cm)
Figure 1-9.
Installation
Gate
Gate support
Chain
posts
#40 Roller
SlideSmart
21"
(53.3cm)
Direction of
gate movement
when opening
Mark the center of
slotted holes (4x) for
concrete anchors:
½ - 13 x 3½"
SECURE SECURE
Concrete
pad
Grade
level
Tip: To keep pinpoint accuracy while drilling
the mounting holes in the concrete, use a
3/16-inch bit to pilot the holes and then move
to a ½-inch drill bit.

Concrete Pad Mount

Left hand gate
(shown in full CLOSE
position)
Chain resides
inside gate
support posts
parallel with the
gate.
Gate support
posts
PUBLIC PUBLIC
½ - 13 x 3½"
concrete
anchors (4x)
Concrete
base
Figure 1-10.
1-7