Entering The Programming Mode; Port Defaults - NEC ux5000 Hardware Manual

2.9.3.1

Entering the Programming Mode

Enter the system programming mode at extension 301:
1.
2.
3.
4.
2.9.3.1

Port Defaults

With the default settings, the ports are assigned as follows:
In the initial configuration:
Chapter 2
Press CALL1. (You hear dial tone).
Dial # * # *.
Dial the system password.
Press HOLD.
Station Ports:
Virtual Station Ports:
Trunk Ports:
All Programmable Function keys are line keys (e.g., key 1 is line 1).
●
All trunks are loop start DTMF.
●
Chapter 2 - Blade Installation and Startup
Password Level
12345678 2 (IN)
0000 3 (SA)
9999 4 (SB)
1-512 (extensions 301-499 and 5000-5312)
1-256 (extensions not assigned)
1-200
2 - 95