Indicators, Switches And Connectors; Switches; Connectors; Installing The Pvau Blade - NEC ux5000 Hardware Manual

Chapter 2 - Blade Installation and Startup
2.6.1.1

Indicators, Switches and Connectors

2.6.1.1.1
2.6.1.1.2
2.6.1.2

Installing the PVAU Blade:

1.
2.
Refer to the Multimedia Conference Server Installation Manual, P/N 0913215, or PVAU NAT
Traversal instructions, P/N 0913106, for complete details on this blade.
2 - 58

Switches

The PVAU has the following switches.
DIP Switch SW1
●
Reserved for future use.
RESET Switch SW3
●
This switch allows the technician to reset the PVAU blade without having to
remove and insert it again in the UX5000 chassis.

Connectors

Ethernet Connector
●
The PVAU has a single 10/100 MPS Ethernet connector. The port has Auto-MDIX
(Auto-Medium Dependent Interface Crossover) giving users the ability use either
a straight-through Ethernet cable or a crossover Ethernet cable. A crossover
cable is not required for direct connection to a PC.
The Ethernet Interface setting allows for manual configuration of the Ethernet port
mode/speed from the Web Interface. This can be set to operate in the following
port speed and duplex mode: 10MB/Full Duplex, 10MB/Half Duplex, 100MB/Half
Duplex, 100MB Full Duplex, Auto-Negotiate.
Serial Connector
●
A 10-pin header (J2) provides access to a serial terminal on the PVAU blade.
The serial connector is used for debug operations only.
Insert the desired CompactFlash into the PVAU blade.
Intall the PVAU into any available slot.
Chapter 2