Setting The Sw1-Sw2 Switches - NEC ux5000 Hardware Manual

2.7.6.1

Setting the SW1-SW2 Switches

In the following cases, the SW1-SW2 switches (6-8 bits on both SW1 and SW2) should be set to the
ON position (default):
Otherwise, the SW1-SW2 switches should be set to the OFF position. If the last port of the ISDN
terminal is connected to a modular rosette with a termination resistor or when using an ISDN
terminal which provides a termination resistor, refer to the ISDN terminal documentation for further
details.
Chapter 2
ISDN Terminal
Interface
Busy LED
Staus LED
Figure 2-40: BRI BLADE AND DAUGHTER BOARD
9.5" 19" Chassis
Chassis w/CCPU
2 5
When the channel is assigned as a T-Bus Point-to-Point.
●
With T-Bus Point-to-Multipoint and if the system is connected at the end of the
●
multipoint.
Chapter 2 - Blade Installation and Startup
Blade Maximum's
19" Chassis 19" Chassis
w/o CCPU
6
System Max.
x4 w/Networking
23 T-Bus: 25
S-Bus: 64
2 - 83