Section 3 How To Enter Programming Mode - NEC SL2100 Programming Manual

SL2100
tells you to enter the programming mode, dial 150701 from the telephone dial pad. After you do, you
will see the message "15-07-01 TEL" on the first line of the telephone display. This indicates the
program number (15-07), item number (01), and that the options are being set for the extension. The
second row of the display "KY01 =
01. The third row allows you to move the cursor to the left or right, depending on which arrow is
*
pressed. To learn how to enter the programming mode, refer to
page 1-2.

Section 3 HOW TO ENTER PROGRAMMING MODE

To enter programming mode :
1. Go to any working display telephone.
In a newly installed system, use extension (port 1).
2. Do not lift the handset.
3. Press Speaker.
4. # # .
* *
5. Dial the system password + Hold.
Refer to the following table for the default system passwords. To change the passwords, use
90-02 : Programming Password Setup on page
Password User Name
12345678 tech
0000 ADMIN1
9999 ADMIN2
1-2
15-07-01
KY01 = *01
-
IP Multiline Terminal
01" indicates that Key 01 is being programmed with the entry of
*
Program Mode
Base Service OP1 OP2
Digital (2W) Multiline Terminal, IP Multiline Terminal
Level
2 (IN) Installation (IN) :
IN, SA and SB levels defined by 90-26 are available.
3 (SA) System Administrator - Level 1 (SA) :
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16, 10-23, 10-28, 10-29,
10-45, 10-67, 12-02, 12-03, 12-04, 12-08, 15-01, 15-07, 15-09, 15-10,
15-11, 20-16, 20-34, 20-57, 20-63, 20-64, 20-66, 20-70, 21-07, 21-14,
22-04, 22-11, 22-17, 25-08, 30-03, 30-04, 32-02, 41-02, 41-03, 41-04,
41-05, 41-06, 41-07, 41-08, 41-09, 41-11, 41-12, 41-13, 41-14, 41-16,
41-17, 41-18, 41-19, 41-20, 45-02, 84-16, 84-22, 90-03, 90-04, 90-06,
90-07, 90-16, 90-19, 90-65, 93-01, 93-02, 93-03, 93-04, 93-05, 93-06
4 (SB) System Administrator - Level 2 (SB) :
13-04, 13-05, 13-06, 13-11, 15-14, 21-20
TEL
+
How to Enter Programming Mode on
2-572.
Programs at this Level
ISSUE 2.0
Introduction