Retrofit Lower Panel Key Module Installation (Figure 4-10 - Figure 4-13) - NEC ux5000 Hardware Manual

Chapter 4 - Terminals and Optional Equipment
4.4.5

Retrofit Lower Panel Key Module Installation (Figure 4-10 - Figure 4-13)

1. Remove any cables from the terminal (line cord, LAN cable, AC power).
2. Remove the right side panel from the terminal. A slot is provided on the bottom of the terminal located
towards the top. Pry the panel away from the terminal.
3. Remove the existing lower panel key kit by prying up the lower plastic panel covering the dial pad area.
Also remove the designation sheet used for labelling the terminal.
Figure 4-11: REMOVE EXISTING KEY MODULE AND SIDE PANEL
4. Remove the lower panel key module. On the lower front edge of the terminal, there is a slot provided to
allow you to pry the module up. (Be careful not to damage the microphone located in the right corner.)
4 - 14
Figure 4-10: RETROFIT LOWER PANEL KEY MODULE
Chapter 4