Entering The Programming Mode; Port Defaults; Setting Up Extension Circuit Types - NEC UX5000 Hardware Manual

2.9.3.1

Entering the Programming Mode

Enter the system programming mode at extension 301:
1.
2.
3.
4.
2.9.3.1

Port Defaults

With the default settings, the ports are assigned as follows:
In the initial configuration:
2.9.4

Setting Up Extension Circuit Types

Use Program 10-03 to set up extension circuit types as required. The system will automatically detect and
assign most circuit types when the device is connected. Refer to the Software Manual for programming
information.
1. Enter 10-03-01.
2. Select the slot, port or channel (with ESIU blades) to be programmed.
3. Set the terminal type or option as needed.
●
Refer to the Software Manual for this information.
●
If the system has DSS Consoles, Program 30-02 must be used to define DSS extension
assignments.
Chapter 2
Press CALL1. (You hear dial tone).
Dial # * # *.
Dial the system password.
Press HOLD.
Station Ports:
Virtual Station Ports:
Trunk Ports:
●
All Programmable Function keys are line keys (e.g., key 1 is line 1).
●
All trunks are loop start DTMF.
Chapter 2 - Blade Installation and Startup
Password Level
12345678 2 (IN)
0000 3 (SA)
9999 4 (SB)
1-512 (extensions 301-499 and 5000-5312)
1-256 (extensions not assigned)
1-200
2 - 91