Section 2 Programming Mode; Entering The Programming Mode; Exiting The Programming Mode; Saving (Backup) The Customer Data - NEC SL1100 Hardware Manual

SL1100
S 2 PROGRAMMING MODE
ECTION

2.1 Entering the Programming Mode

The installer/system administrator can enter to the system programming mode from the Display Type
Multiline Telephone. (A maximum of two users can enter mode at the same time)
In a newly installed system, use extension port 1.
1. Press Speaker key. (Do not lift the handset)
2. Dial # * # * .
11-10 WED 1:49PM
200
Menu Dir VM:00 CL:00
3. Dial the system password, then press Hold key to enter the Program Mode.
Password@@@@@@@@
For the details of programming, refer to the SL1100 Programming Manual. (separate issue)

2.2 Exiting the Programming Mode

1. Press Mute key several times to return to the "Program Mode" Screen.
10-01-
Time&Date Setup
back

Figure 3-8 Exiting the Programming Mode Display 1

2. Press Speaker key to exit.
Program Mode
Base Service OP1 OP2
The system automatically saves the customer data to the memory which is backed up by lithium battery.

2.3 Saving (Backup) the Customer Data

When the installer/system administrator exits from the programming mode, the system will automati-
cally save the customer data to the on-board memory which is backed up by lithium battery.
Additionally, the customer data can be saved to a CF Card for backup purpose. The BLANK CF card
is inserted to the CF slot on the VMDB.
1. Turn the system power off, insert the blank CF card (32 MB or larger) to the CF slot on VMDB.
3-4

Figure 3-6 Entering Programming Mode Display 1

Figure 3-7 Entering Programming Mode Display 2

Sys Config
|01
Select

Figure 3-9 Exiting Programming Mode Display 2

Password
Program Mode
Base Service OP1 OP2
Program Mode
Base Service OP1 OP2
11-10 WED 1:49PM
200
Menu Dir VM:00 CL:00
ISSUE 1.0
System Start Up