Connector Pin-Outs On Coiu Blade; Installing The Analog Trunk Blade - NEC ux5000 Hardware Manual

2.7.1.2

Connector Pin-Outs on COIU Blade

2.7.1.3

Installing the Analog Trunk Blade:

●
1.
For details on the connections for power failure trunks, refer to "Section 4-16 POWER FAILURE
TERMINALS" on page 4-65.
Chapter 2
The CN2 connector is polarity sensitive (tip to tip, ring to ring) for
12345678
RJ61 Cable Connector - CN3, SLT Interface for Power Failure
12345678
If the 4COIDB is to be used, install this prior to inserting the COIU blade into
the chassis.
Install the COIU into any available slot.
Use Program 14-02-14 to set the trunks as loop or ground start. Loop and ground starts
●
can be combined on one blade.
Chapter 2 - Blade Installation and Startup
RJ61 Cable Connector - CN2, Trunks
ground start trunks.
Pin No.
1
2
3
4
5
6
7
8
Pin No.
1
2
3
4
5
6
7
8
Connection
Circuit 4 - Tip
Circuit 3 - Tip
Circuit 2 - Tip
Circuit 1 - Ring
Circuit 1 - Tip
Circuit 2 - Ring
Circuit 3 - Ring
Circuit 4 - Ring
Connection
-
-
Circuit 2 - Tip
Circuit 1 - Ring
Circuit 1 - Tip
Circuit 2 - Ring
-
-
2 - 65