When Using Caller Id - NEC ux5000 Hardware Manual

Hide thumbs Also See for ux5000:
Table of Contents

Advertisement

Chapter 2 - Blade Installation and Startup
A DSP is used on the system's CCPU which has the call. For instance, when a trunk on System ID 2
uses a receiver, a DSP on System ID-2 is used.
A UX5000's CygniLink ID will determine which zone it's in. In the same zone, the communication
servers must share the DSP resource
user in System ID-1 is using DSP resource #1, resource #1 becomes busy in Zone #1 (System ID 1,
6, 11, 16, 21, 26, 31, 36, 41, 46). However, in a different zone, that same resource number is
available for use. Each zone has a maximum of 96 DSP resources that can be used at one time (32
on the base chassis, 64 on the expansion chassis).
All communication servers within the CygniLink network follow the DSP setting Program 10-09-01 :
DTMF and Dial Tone Circuit Setup in the primary system to determine the type of usage for the
DSP resource (example: common, extension only, trunk only).
The 64-port Conference circuit is independent from these resources.
2.4.1.2.1
2 - 18

When Using Caller ID

When Program 10-09 is set for 0 (common) and if Program 14-02-10 (Caller ID) is set to
"Yes":
These DSP resources are allocated to the trunk side to monitor the Caller ID. For
example, if there are 8 Caller ID-enabled trunks and 16 DSP resources are
programmed as common, the first 8 DSP resources will be allocated to only trunk ports,
even though Program 10-09 is set as common (limitation). However, the last 8
resources can be used for both extensions and other trunk ports. If Program 14-02-10 is
set to "No", all 16 DSP resources set as common can be used for both trunk and
extension ports.
Sending Caller ID to analog extensions is performed using a DSP resource, not the
DSP sender, so Program 10-09 has to be set to "1" (extensions) or "0" (common).
DSP Resource
Call Progress Tone Detecting
DTMF Receiving From Trunk/Extension
Caller ID Receiving From Analog Trunk
Caller ID Sending to Analog Extension
MF Receiver From T1 ANI
MFC Receiver From E1
number
(not the actual resource however). For instance, if a
14-02-10
Caller ID
Don't Care
Yes
No
Don't Care
Yes
No
Don't Care
Don't Care
From/To
From Trunk
Extension
OK
-
OK
Limitation
OK
OK
-
-
Limitation
-
OK
OK
-
OK
-
Chapter 2

Advertisement

Table of Contents
loading

Table of Contents