Using The Lock Feature On Ip-Cts Or Enhanced Terminals - NEC ux5000 Hardware Manual

4.18.8

Using the Lock Feature on IP-CTS or Enhanced Terminals

The Lock button on the IP-CTS or IP Enhanced terminals will provide a user with the ability to prevent calls
on their terminal while away from their desk. This will prevent all calls from being dialed - including 911
(unless allowed by changing the terminal's setup (as defined above).
1. Press the LOCK button at the top of the IP-CTS or IP Enhanced terminal.
2. The screen displays "Security Lock?". Press the OK Soft Key to enable or CANCEL to exit without setting
the feature.
3. To clear the Lock feature, press any key. The screen request the password entry. Dial the 4-digit
password for the terminal and press the OK Soft Key.
Chapter 4
The screen displays a screen saving while locked and the Lock LED will be lit.
●
The terminal returns to an idle condition. If required, the UX5000 administrator can reset
●
the terminal if a password is forgotten.
Chapter 4 - Terminals and Optional Equipment
4 - 77