Installing The Gba Adapter - NEC ux5000 Hardware Manual

4.15.7.2 Installing the GBA Adapter:

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
LAN Connection
PC Connection
To LAN Connection
on Terminal
Chapter 4
Disconnect any cables to the IP terminal and turn the terminal upside down.
Lower the legs of the terminal and remove the leg bracket by pressing the tabs on the leg
bracket. Refer to 4.20.3 Removing/Attaching the Legs on page 4-88 for further details.
Attach the LAN cable to the terminal and route the cable into the channel on the bottom of the
terminal.
Attach the DC power cable to the terminal and route the cable into the channel on the bottom
of the terminal.
Attach the GBA support panel to the bottom of the terminal.
Route the power and LAN cables into the cable guides on the support bracket.
Return the terminal to an upright position.
Connect the LAN cable from the IP terminal into the "IP PHONE" connection on the adapter.
Do not connect a LAN cable from any other source but the IP terminal to this
●
connection. It could damage the equipment.
If required, connect the LAN cable from the PC to the "PC(X)" connection.
Do not connect a LAN cable from any other source but the PC to this connection. It
●
could damage the equipment.
Connect the DC power cable from the IP terminal to the DC Out connection on the GBA
adapter.
Attach the noise filter to the network LAN cable, placing it at the end of the cable closest to the
GBA adapter connection point.
Connect the AC power cable into the DC In connection.
Figure 4-32: INSTALLED GIGABIT ADAPTER
Chapter 4 - Terminals and Optional Equipment
DC Cable to AC Wall Outlet
GBA Support Panel
GBA Adapter
DC Cable to
Terminal Connection
4 - 59