Chapter 4 - Terminals and Optional Equipment
4.2.3
Setting Up 2PGDAD Module Connections
If the 2PGDAD Module is to be wall mounted, it is recommended that all the cable connections be made
●
first.
In order for the module to ID correctly after setting the jumpers, if the port to be used was previously
●
assigned, set the circuit type to "0" for the module's port in Program 10-03-01 prior to connecting the line
cord to the 2PGDAD Module.
1. Remove the screw from the front of the 2PGDAD module.
2. Using a screwdriver, break out the plastic piece covering the cable hole.
4 - 4
Figure 4-2:
REMOVE COVER FROM 2PGDAD MODULE
Figure 4-3: REMOVE PLASTIC COVER FROM CABLE HOLE
Module
Breakout plastic
for cable access
Chapter 4