Installing The Sensor Board - Dell PowerEdge C6320p Owner's Manual

Figure 124. Removing the sensor board
4. Remove the screw that secures the sensor board to the sensor board holder.
5. Remove the sensor board from the sensor board holder.
Next steps
1. Install the sensor board
2. Install the hard drive cage.
3. Reconnect all the disconnected cables.
4. Install the hard drives
5. Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing a hard drive carrier

Installing the sensor board

Installing a hard drive carrier
After working inside your system
Installing the sensor board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
NOTE: You must route these cables properly on the chassis to prevent them from being pinched or crimped.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove all the hard drives.
4. Remove the hard drive cage.
5. Disconnect all the cables connected to the backplane and sensor board.
176