Installing The Sensor Board For 3.5 Inch Hard-Drive System - Dell PowerEdge C6320 Owner's Manual

5. Disconnect front panel cables from the power distribution board.
NOTE: Observe the routing of the cable on the chassis as you remove them from the system.
You must route these cables properly when you replace them to prevent the cables from being
pinched or crimped.
6. Remove the hard drive cage from the chassis.
7. Disconnect the cable from the sensor board.
8. Remove the screw that secures the sensor board to the hard drive cage.
9. Remove the sensor board from the hard drive cage.
Figure 97. Removing and installing the sensor board
1. sensor board
Related Information
Removing a hard-drive
Opening the system

Installing the sensor board for 3.5 inch hard-drive system

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Replace the sensor board into the hard drive cage.
2. Replace the screw that secures the sensor board to the hard drive cage.
3. Connect the sensor board cable to the sensor board.
4. Replace the hard drive cage into the chassis.
5. Replace the screws that secure the hard-drive cage to the chassis.
6. Connect all the cables to the backplane.
2. screw
121