System Memory; Memory Slot Features; Supported Memory Module Configuration - Dell PowerEdge C6320p Owner's Manual

Hide thumbs Also See for PowerEdge C6320p:
Table of Contents

Advertisement

NOTE: Ensure that neither of the cables are pinched or pressed under the air shroud.
2.
Press the air shroud until the locks click into place.
Figure 23. Installing the air shroud
Next steps
1.
Install the sled into the enclosure.
2.
Follow the procedure listed in the After working inside your system section.

System memory

System memory holds the instructions that the processor runs. Each system board has six DDR4 memory module sockets for the
installation of DDR4-2400 MHz (2400 MHz at one DIMM per channel) memory modules. For the location of the memory modules,
see the PowerEdge C6320p system board connectors section.

Memory slot features

Support 6 channels, up to six DDR4 Registered DIMMs (RDIMMs) and Load Reduced DIMMs (LRDIMMs)
Speed up to 2400 MT/s
Maximum capacities: 384 GB with 64 GB LRDIMM
Supports DDR4
Supports Error Correction Code (ECC)
NOTE: Linux operating system does not support the S4 (hibernation) mode.

Supported memory module configuration

For the sequence of the six memory-module sockets, the system requires at least one memory module installed in DIMM slot A1 to
boot up. When you insert the memory modules, always start with CH0_A1. The optimized memory module installation sequence is A1,
(A1, D1), (B1, E1), (C1, F1).
69

Advertisement

Table of Contents
loading

Table of Contents