Installing The Sensor Board For 3.5-Inch Hard Drive System - Dell PowerEdge C6320 Owner's Manual

NOTE: Observe the routing of the cable on the chassis as you remove them from the system. You
must route these cables properly when you replace them to prevent the cables from being pinched
or crimped.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove all the hard drives.
4. Disconnect all the cables from the backplane.
5. Disconnect front panel cables from the power distribution board.
Steps
1. Remove the hard drive cage from the chassis.
2. Disconnect the cable from the sensor board.
3. Remove the screw that secures the sensor board to the hard drive cage.
4. Remove the sensor board from the hard drive cage.
Figure 104. Removing and installing the sensor board
1. sensor board
Related Links
Safety instructions
Before working inside your system
Removing a hard drive
Removing the system cover

Installing the sensor board for 3.5-inch hard drive system

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
156
2. screw