Removing The Mezzanine Card Bridge Board - Dell PowerEdge C6320p Owner's Manual

Removing the mezzanine card bridge board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the sled from the enclosure.
4. Remove the expansion card riser assembly.
5. Remove the mezzanine card.
6. Keep the Phillips #2 screwdriver ready.
Steps
Pull the mezzanine card bridge board away from the mezzanine card slot on the system board.
Figure 65. Removing the mezzanine card bridge board
Next steps
1. Install the mezzanine card bridge board.
2. Install the mezzanine card.
3. If a mezzanine card is not used, install the mezzanine bracket.
4. Install the expansion card riser assembly.
5. Install the sled into the enclosure.
6. Follow the procedure listed in the After working inside your system section.
117