Installing The Sata Cable Into The Sled - Dell PowerEdge C6320p Owner's Manual

Figure 33. Installing the SSD SATA cable
Next steps
1. If removed, install the SATA cable.
2. If removed, install the PCIe expansion card riser assembly.
3. Install the air shroud.
4. Install the sled into the enclosure.
5. Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing a sled
Removing the air shroud
Removing the SATA cable from the sled
Removing the expansion card riser assembly
Installing the expansion card riser assembly

Installing the SATA cable into the sled

Installing the air shroud
Installing a sled
After working inside your system
Installing the SATA cable into the sled
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
NOTE: Observe the routing of the cable as you remove it from the system. Route the cable properly when you replace it
to prevent the cable from being pinched or crimped.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
81