Next steps
1.
If removed, install the expansion card.
2.
Install the expansion card riser assembly.
3.
Install the sled into the enclosure.
4.
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing a sled
Removing the expansion card riser assembly
Removing an expansion card
Installing an expansion card
Installing the expansion card riser assembly
Installing a sled
After working inside your system
Removing the cables from the fabric carrier card
Prerequisites
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Remove the sled from the enclosure.
Steps
1.
Pressing the button on top of the fabric connector, release and slide the connector and cable away from the fabric carrier card.
Figure 59. Removing the fabric cable from the fabric expansion card
2.
Release the side band cable from the cable clamp.
3.
Holding the cable connector, pull the connector away to release the cable from the socket on the system board.
110