Removing The Memory Modules - Dell PowerEdge C6320p Owner's Manual

Figure 24. DIMM slot locations
Table 27. Memory module population
CH0
Memory modules
1
2
4
6
NOTE: The Poweredge C6320p does not support:
• RAS modes (Advanced ECC, Sparing, Mirroring, and Fault Resilient configurations).
• mixed configurations. All populated DIMMs must be identical.
• three and five DIMMs configurations.
NOTE:

Removing the memory modules

Prerequisites
WARNING: The memory modules are hot to the touch for some time after the system has been powered down. Allow
time for the memory modules to cool before handling them. Handle the memory modules by the card edges and avoid
touching the components on the memory module.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the sled from the enclosure.
4. Remove the air shroud.
Steps
1. Locate the appropriate memory module socket.
70
CH1
A1 B1
√ ‒
√ ‒
√ √
√ √
CH2 CH3
C1 D1
‒ ‒
‒ √
‒
√
√ √
CH4 CH5
E1 F1
‒ ‒
‒ ‒
‒
√
√ √