6.
Keep the Phillips #1 screwdriver ready.
Steps
1.
Install the sensor board into the sensor board holder and secure it with the screw.
2.
Connect the sensor board cable to the sensor board.
3.
Install the sensor board assembly into the hard drive cage.
4.
Insert the screws that secure the sensor board to the hard drive cage.
Figure 125. Installing the sensor board
Figure 126. Installing the sensor board assembly
Next steps
1.
Replace the hard drive cage into the chassis.
2.
Connect all the cables to the backplane.
3.
Connect the control panel cables to the power distribution board.
4.
Install the hard drives.
5.
Follow the procedure listed in the After working inside your system section.
177