Related links
Safety instructions
Before working inside your system
Removing a sled
Removing the expansion card riser assembly
Removing a mezzanine card
Installing the mezzanine card bridge board
Installing the expansion card riser assembly
Installing a sled
After working inside your system
Installing the mezzanine card bridge board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Remove the sled from the enclosure.
4.
Remove the expansion card riser assembly.
5.
Remove the mezzanine card.
6.
Keep the Phillips #2 screwdriver ready.
Steps
Insert the mezzanine card bridge board into the mezzanine slot on the system board.
NOTE: The mezzanine card bridge board has an alignment key to ensure that it can only be installed in one way.
Installing the bridge board incorrectly may damage the bridge board, the mezzanine card, and the system board.
118