Table of Contents
Advertisement
Figure 81. Installing a hard drive into a hard drive carrier
NOTE: Ensure that the hard drive is installed with the label facing up. This is to ensure that the hard drive connector
is aligned with the connector on the backplane.
Next steps
1.
Install the hard drive carrier into the hard drive bay.
2.
To check the status of the hard drive, see the hard drive activity and status indicators.
3.
To verify the status of the installed hard drive, check the management software.
Related links
Safety instructions
Removing a hard drive carrier
Installing a hard drive carrier
Hard drive indicator patterns
Power supply units
NOTE: Using configurations higher than indicated in the table may change the power supply units (PSU) mode to non-
redundant. In non-redundant mode, if the power requirement exceeds the installed system power capacity, the BIOS will
throttle the processors performance. Also, when Processor Power Capping is enabled, processor throttling occurs on
configurations that exceed the cap value.
NOTE: Both the PSUs are hot swappable if the system has the power throttling feature enabled.
The following table lists the maximum supported configurations where power supply unit (PSU) redundancy is guaranteed:
138
Advertisement
Table of Contents
Troubleshooting
