Processor And Heat Sink Module - Dell PowerEdge C6320p Owner's Manual

3. Remove the sled from the enclosure.
4. Remove the air shroud.
Steps
1. Open the cable retention lock.
2. Connect the SATA cable to the connector on the system board until the clips click into place. Repeat this step with the
connector at the other end of the cable.
3. Close the cable retention lock.
NOTE: Ensure that the cable is inside the edge of the sled metal edge. The cable should not be on top or outside the
edge. If the cable is not inside the sled edge it may get damaged when the sled is installed in the chassis.
Figure 34. Installing the SATA cable
Next steps
1. Install the air shroud.
2. Install the sled into the enclosure.
3. Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing a sled
Removing the air shroud
Installing the air shroud
Installing a sled
After working inside your system

Processor and heat sink module

WARNING: Sleds using the Intel Xeon Phi 72XX and Phi 72XXF processors must not be installed in the same enclosure.
CAUTION: This is a Field Replaceable Unit (FRU). Removal and installation procedures must be performed only by Dell
certified service technicians.
82