Dell PowerEdge C6320p Owner's Manual page 47

Option Description
Option
Level 2 Cache
Number of Cores
Microcode
Related links
Processor Settings
Viewing Processor Settings
SATA Settings
You can use the SATA Settings screen to view the SATA settings of SATA devices and enable RAID on your system.
Related links
SATA Settings details
System BIOS
Viewing SATA Settings
Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click SATA Settings.
Related links
SATA Settings
SATA Settings details
SATA Settings details
The SATA Settings screen details are explained as follows:
NOTE:
• Port A is for the internal SATA SSD.
• Ports B — G are for the six front panel hard drives.
Option Description
Embedded SATA Enables the embedded SATA option to be set to Off, ATA, orAHCI modes. This option is set to AHCI by
default.
Security Freeze Sends Security Freeze Lock command to the Embedded SATA drives during POST. This option is applicable
Lock only for ATA and AHCI modes.
Write Cache Enables or disables the command for Embedded SATA drives during POST.
Port A Sets the drive type of the selected device. For Embedded SATA settings in ATA mode, set this field to Auto
to enable BIOS support. Set it to OFF to turn off BIOS support.
For AHCI mode, BIOS support is always enabled.
Description
Specifies the total L2 cache.
Specifies the number of cores per processor.
Indicates the Microcode update signature.
47