Table of Contents
Advertisement
Figure 60. Removing the side band cable from the fabric carrier card
Next steps
1.
Connect the fabric cable to the carrier card.
2.
Install the sled into enclosure.
3.
Follow the procedure listed in the After working inside your system section.
Connecting the cables to the fabric carrier card
Prerequisites
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Remove the sled from the enclosure.
Steps
1.
Insert the fabric cable connector into the connector slot on the carrier card and push the connector until it locks into place.
111
Advertisement
Table of Contents
Troubleshooting
