Siemens SINAMICS S120 Installation And Start-Up Manual page 127

Error values in DPV1 parameter responses
Table 4-17 Error values in DPV1 parameter responses
Error Meaning
value
0x00 Illegal parameter number
0x01 Parameter value cannot be
changed
0x02 Lower or upper value limit
exceeded
0x03 Invalid subindex
0x04 No array
0x05 Wrong data type
0x06 Illegal set operation (only reset
allowed)
0x07 Description element cannot be
changed
0x09 No description data
0x0B No operating priority
0x0F No text array exists
0x11 Request cannot be executed due
to operating status
0x14 Illegal value
0x15 Response too long
0x16 Illegal parameter address
0x17 Illegal format
0x18 No. of values inconsistent
0x19 Drive object does not exist
E Siemens AG, 2004. All rights reserved
SINAMICS S120 Installation and Start-Up Manual, 12/04 Edition
Communication via PROFIBUS
Comments
Access to a parameter which does not exist.
Modification access to a parameter value
which cannot be changed.
Modification access with value outside value
limits.
Access to a subindex which does not exist.
Access with subindex to an unindexed
parameter.
Modification access with a value which does
not match the data type of the parameter.
Modification access with a value not equal to
0 in a case where this is not allowed.
Modification access to a description element
which cannot be changed.
Access to a description which does not exist
(the parameter value exists).
Modification access with no operating priority.
Access to a text array which does not exist
(the parameter value exists).
Access is not possible temporarily for
unspecified reasons.
Modification access with a value which is
within the limits but which is illegal for other
permanent reasons (parameter with defined
individual values).
The length of the present response exceeds
the maximum transfer length.
Illegal or unsupported value for attribute,
number of elements, parameter number,
subindex or a combination of these.
Write request: illegal or unsupported parameter
data format.
Write request: a mismatch exists between the
number of values in the parameter data and
the number of elements in the parameter
address.
You have attempted to access a drive object
that does not exist.
Acyclic communication
Add.
informa-
tion
-
Subindex
Subindex
Subindex
-
-
Subindex
Subindex
-
-
-
-
Subindex
-
-
-
-
-
4-127