Line - HP FlexFabric 7900 Series Command Reference Manual

Parameters
minutes: Specifies the number of minutes for the timer, in the range of 0 to 35791. The default is 10
minutes.
seconds: Specifies the number of seconds for the timer, in the range of 0 to 59. The default is 0
seconds.
Usage guidelines
The system automatically terminates the user connection on the user line if there is no information
interaction between the device and the user within the idle-timeout interval.
Setting the CLI connection idle-timeout timer to 0 disables the idle-timeout feature.
This command is available in both user line view and user line class view:
•
If the setting in user line view is not the default setting, the setting in user line view takes effect.
•
If the setting in user line view is the default setting but the setting in user line class view is not,
the setting in user line class view takes effect.
Examples
# Set the CLI connection idle-timeout timer to 1 minute and 30 seconds for user line AUX 0.
<Sysname> system-view
[Sysname] line aux 0
[Sysname-line-aux0] idle-timeout 1 30

line

Use line to enter one or multiple user line views.
Syntax
line { first-number1 [ last-number1 ] | { aux | vty } first-number2 [ last-number2 ] }
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
first-number1: Specifies the absolute number of the first user line. The value range is 0 to 65 in
standalone mode and 0 to 71 in IRF mode.
last-number1: Specifies the absolute number of the last user line. This number cannot be smaller
than first-number1.
aux: Specifies the AUX line.
vty: Specifies the VTY line.
first-number2: Specifies the relative number of the first user line. The value ranges are as follows:
AUX line—0 to 1 in standalone mode and 0 to 7 in IRF mode.
•
VTY line—0 to 63.
•
last-number2: Specifies the relative number of the last user line. This number cannot be smaller than
first-number2.
Usage guidelines
To configure settings for a single user line, use this command to enter the user line view.
29