User-Interface - HP FlexFabric 7900 Series Command Reference Manual

Default
The terminal display type is ANSI.
Views
User line view, user line class view
Predefined user roles
network-admin
mdc-admin
Parameters
ansi: Specifies the terminal display type ANSI.
vt100: Specifies the terminal display type VT100.
Usage guidelines
The device supports two terminal display types: ANSI and VT100. As a best practice, set the display
type to VT100 on both the device and the configuration terminal. If either side uses the ANSI type, a
display problem such as cursor positioning error might occur when a command line has more than
80 characters.
Examples
# Set the terminal display type to VT100.
<Sysname> system-view
[Sysname] line vty 0
[Sysname-line-vty0] terminal type vt100

user-interface

Use user-interface to enter one or multiple user line views.
Syntax
user-interface { first-number1 [ last-number1 ] | { aux | vty } first-number2 [ last-number2 ] }
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
first-number1: Specifies the absolute number of the first user line. The value range is 0 to 65 in
standalone mode and 0 to 71 in IRF mode.
last-number1: Specifies the absolute number of the last user line. This number cannot be smaller
than first-number1.
aux: Specifies the AUX line.
vty: Specifies the VTY line.
first-number2: Specifies the relative number of the first user line. The value ranges are as follows:
AUX line—0 to 1 in standalone mode and 0 to 7 in IRF mode.
•
VTY line—0 to 63.
•
45